1951-52 light loom boot

Started by James, December 28, 2007, 03:18:33 AM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Go Fleiter

I too had to use general purpose rubber grommets. I just made one cut into them  and worked them over the cables without bothering with taking the contact rivets etc. off. The cut doesn?t disturb the finktion. Hoping to fing an original replacement assembly....
Greeetings and happy new Year to all! Go
Living in Düsseldorf/Germany, retired Dentist, wife retired lawyer, 2 daughters Judge and psychologist, 3 Grandchilds-Sorry for bad English
I like- PennsyRR- travelling Europe in my very original 51 Ply- My whole basement HO Germany based Model Railroad- 50ties stuff- Italy
  •  

Edwin K.

I had the same problem on 1950 tail light assemblies. I purchased rubber grommets from Restoration Specialties (PA) at 814-467-9842. I can't find the ones I had left ove from the project. An invoice shows rubber hole plug SCR-200722 at $1.55 each. I think that's the right one. Call the company. I can't finda picture of that piece in their catalog. Basically it was a grommet that, with a little trimming, would fit through the hole in the body sheet metal. The center hole was ok for the plastic sheath that contained the two wires for the tail light. The result didn't look exactly like the old setup (no brass ferrule) but it did the job and looked good.
  •  

John Hendricks

Until u find the right one, would a sparkplug boot work?  Hard to tell size from the photo.
John Hendricks
  •  

James

Does anyone know of a source for the rubber boot that secures the headlight or parking light looms to the body.
The photo shows the parking light loom assembly. The end of the boot (that goes through the body sheet metal) is separated (torn-off during disassembly) from the rest of the boot. Please see attached photo.
  •