Gas Cap replacement

Started by Bob Bond 117, July 22, 2026, 01:32:25 PM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

Rip VW

I know this thread is several months old but I had an interesting gas cap adventure concerning caps fitting on my 1939 P7 Road King. The vent in my original cap quit venting so time for a new cap. I bought one from burnbaum and tried to install it and t wouldn't fit. It fit on the pipe but you were unable to turn the cap to tighten it up. It just wouldn't turn. I discovered the thin Washer under the rubber seal was a spring type washer except it refused to spring. I tried pressing it with thumb pressure but it would not move. I then got a small stick and placed it on the rubber washer I then likely tapped the end of the stick with a small hammer all the way around the washer. These were light taps and the face of the cap was placed into a pile of soft rags. During the tapping I felt the washer move slightly. I then used my thumbs to press on the rubber gasket and it started springing. I took the cap out to the car and the cap went right on and tightened normally. I guess it may have been assembled slightly off set and trapped the spring.  The washer under the rubber seal is a spring like washer to my best guess. Anyway if you have a stubborn cap the internals my be mis-assembled or mis aligned. Anyway if helps some one solve the gas cap problem I am glad to be of help.
  •  

Bill Davis

I just looked on the NAPA website and had an idea or question.  A notation on that fuel cap is that it fits US made vehicles.  Was your car made in Canada or made for export?  If so, this might be why you cannot find a cap that fits.  ??????
-Bill Davis, Killen,AL
1951 Plymouth P-23 Cambridge 4 door
  •  

Bill Davis

Andy Bernbaum shows that 1953 & 1954 Chrysler, DeSoto, Dodge & Plymouth take the same cap.  Is this not true ?
-Bill Davis, Killen,AL
1951 Plymouth P-23 Cambridge 4 door
  •  

Bob Bond 117

Does anyone know where to find an OEM replacement gas cap.  The ones that are recommended do not fit the 1953 Plymouth Cranbrook.  I've tried NAPA, O'Rielly's, and just about every outlet out there and they all recommend the same one and still does not fit.  Suggestions?
Bob Bond 117
Robert F Alfaro
  •