Transmission mounts (insulators) - replacement source

[Scott55Ply]

Thank you Bob & Elmo.  I always check with NAPA first; this time they disappointed me.  I have the catalogues you refer to, but the mounts are not specifically listed for my car. The mount you refer to Elmo is almost identical & is one digit off from that listed in the Steele catalogue - I'll check with Chris Suminiski for his advice.  My mounts do have a tubular shaft that ptotrudes through the mount fo an additional 5/8" at the bottom & a large washer below prevents the trans. from rising further.  Seems a bit strange & I would think the freeplay would add stress to the single front engine mount. I asume the mounts I have are original.  They are in decent shape for 28,000 miles & 56 years of age.  (Alaska is very good to rubber & chrome parts.) I re-installed the old mounts but will pursue new mounts.

Thank you again.  The POC & this forum are wonderful!

Scott Grundy

[elmo]

try steelerubber.com , they have them listed in there parts catalog. there part #is 40-0411-11.

[RC Drown]

Did you check with Andy Bernbaum or Pro Antique Auto Parts?

Do they have NAPA in Alaska?  If so, you might check with them.

Hope this helps,
Bob

[Scott55Ply]

Looking for replacement mounts for a 1955 Ply. with a Powerflite automatic transmission & a V8 engine.  The MOPAR number on the original three inch circular mounts is: 1404 337 AT.  I need two. Thank you, Scott Grundy