Turn Signals 40 Ply P-9

[chetbrz]

You need an independent run to each of the rear brake lights.? This way left will blink with left and right will blink with right.? The brake light wire needs to go from the Master cylinder switch to the Flasher Assembly and then is sent from the flasher assembly to each brake lamp.? If any of the wiring is connected together both lamps will blink with either left or right activated.

If this isn?t clear shoot me an email.? See wiring diagram below from my 29 Plymouth it is basically the same for any system.



Chet?

[Don St Peter]

I installed a standard 7 wire turn signal switch ( everlasting Model HL-101 ) on my 6V original 40 Ply P-9. I used a new 6 Volt flasher (Model 535 from NAPA) and wired per the signal switch instructions.
I spliced into each of my existing single filament front park light wires with two new and separate wires, since I've chosen to use the park lights as my front turn signals.
Everything works fine except...... both rear turn signals ( brake light filaments ) flash when I select either right or left turn. I can not figure out whats going on since I ran new and seperate wires to the rear and spliced into the existing stop light wires. Anyone have any idea why I get BOTH flashing when I select left, then right?
Flashers wires switched has been eliminated as the problem.
Thanks in Advance
Don