need Detroit ball & trunion setup for front and rear for 56 plymouth, V-8, automatic.
leads, referrals appreciated.
thankyou
jerry whitfield
winston salem NC
336-765-8312
The usual suspects should be able to help you. Bernbaum, Mitchell, Roberts, etc. I'd call Roberts first. Be advised that these are not cheap, if you are not in to authenticity it may be cheaper to have a new drive shaft made up using "off the shelf" universal joints.
For contact information you can see my web site: http://www.ply33.com/Parts/vendor
Quote from: jerrybev on November 02, 2008, 10:33:51 PM
need Detroit ball & trunion setup for front and rear for 56 plymouth, V-8, automatic.
leads, referrals appreciated.
thankyou
jerry whitfield
winston salem NC
336-765-8312
Is one from a 55 DeSoto 2-speed automatic the same as the one you are looking for? If it is,I can help you. I still have the engine and trans I pulled from the 55 DeSoto I sold.
Quote from: TodFitch on November 02, 2008, 11:55:15 PM
For contact information you can see my web site: http://www.ply33.com/Parts/vendor
Todd,your page is down.
Quote from: Bender on November 30, 2008, 06:19:16 PM
Todd,your page is down.
Glitch on the server. Not sure what caused it but I think everything is back up now.
There were recently some rebuild kits on Ebay for approx.$400. As Todd suggested, if you are OK with modern technology and servicing, a driveshaft shop in our west coast area, for example, wanted $395 to make a new balanced shaft with Spicer ends to match Plymouth mating flanges.