My '37 engine is in the machine shop for overhaul. The shop has asked me for some specs. I have been unable to find. Does anyone know the diameter of a standard crankshaft for a '37 P4? It is the 201 cubic inch engine. The machine shop is trying to determine amount of wear and what rod and main bearings to use.
If you don't know but know where I can look to find it, please advise.
Thanks.
Bearing specs for 201 engine Main bearing 2.249 - 2.250 "
Rods 1. 9375 "
David,
Thank you very much!
Everyone put this information in you Service manual since it is not there.