Print Page - PB Blaster and Kroil-?

Title: PB Blaster and Kroil-?
Post by: DENNIS P NOLAN on February 08, 2008, 11:50:11 AM

I am looking to get some rusted bolts off an exhaust manifold-I have the replacement manifold and am looking for the products suggested- Kroil and PB Blaster-?..the best place to get them-?..Thank you!!! Dennis

Title: Re: PB Blaster and Kroil-?
Post by: Carmen on February 08, 2008, 12:08:19 PM

For me Kroil is the best by far. I have use it on both my Jeep and truck and will be using it for the Plymouth.

Carmen

Title: Re: PB Blaster and Kroil-?
Post by: Jim Yergin on February 08, 2008, 04:04:35 PM

I buy PB Blaster at my local auto parts store. You can order Kroil at this web site:

http://www.kanolabs.com/

Jim Yergin

Title: Re: PB Blaster and Kroil-?
Post by: samiam0821 on February 08, 2008, 07:02:34 PM

I have only used BP Blaster, so I can only comment on it, but it sure did a great job of restoring my rubber sill mats. See my other recent post. I have pictures of before and after. Camille

Title: Re: PB Blaster and Kroil-?
Post by: martyb on February 08, 2008, 10:56:28 PM

I've been impressed by Kroil. When I first tried to remove the mounting bolts on the bumpers of my 47 Plymouth, they didn't even move. I then took a can of AeroKroil and soaked all of them and left them overnight. The next morning all of the nuts came off with little effort. Very good stuff!

Marty

Title: Re: PB Blaster and Kroil-?
Post by: JimCno on February 09, 2008, 06:47:05 PM

I've bought PB Blaster at the hardware store, I haven't seen Kroil sold anywhere.

The other option is to use a nut buster or cut it off with a cutting wheel on a Dremel tool, then replace with new bolts.

Plymouth Owners Club

General Category => Technical Discussion => Topic started by: DENNIS P NOLAN on February 08, 2008, 11:50:11 AM